Detcon Sensor Duct Mount Kit FP/TP/DM/IR Series User Manual

Sensor Duct Mount KitFP Series PN 975-000020-890, FP Series PN 975-R00020-890 TP Series PN 975-000020-891, TP Series PN 975-R00020-891DM Series PN 975

1.0 DescriptionThe Detcon Sensor Duct Mount Kit allows a Detcon gas sensor assembly to be mounted so that its sensor islocated inside of an air duct,

1.2 Installation1.2.1 ASSEMBLYNOTE: If the duct mount and sensor are already assembled as one unit, skip to the “Installation” instructions(section 1

2 - Assemble the sensor assembly to the duct mount kit.a) Screw the rain shield onto the sensor housing.b) Apply teflon tape to the sensor housing 3/4

1.2.2 INSTALLATION1 - Cut clearance hole in duct as shown below. Cutout is the same for square or round ducts.2 - Mount the duct mount kit using four

Detcon Duct Mount Kit PG.6Square DuctSide ViewSide ViewRound DuctSide ViewSide ViewIf 1/4" foam gasket does notcompletely fill openings incutout

1.3 CalibrationCAUTION: In high velocity air ducts, air flow may need to be shut down before calibration takes place. 1 - Verify that there is no air

Detcon Duct Mount Kit PG.8